Titanium and composite resin, both of which had no reaction on LST, were used in replacements of the intraoral restoration after the pruritus improved;
however, cervical selleckchem eczema emerged after 9 months, and repeat LST showed a specific reaction to Ti. The eczema improved after removal of the titanium. It is therefore likely that Ti allergy provoked the eczema. This report suggests that clinicians should be aware of the possibility of a titanium allergy from a dental restoration. “
“Purpose: The aim of this study was to determine effect of compressive cyclic loading on fatigue resistance and microleakage of monolithic CAD/CAM molar ceramic and composite crowns. Materials and Methods: Thirty-two Decitabine extracted molars were prepared to receive CEREC crowns according to manufacturer’s guidelines using a special paralleling device (Parallel-A-Prep). Sixteen feldspathic ceramic crowns (VITABLOCS Mark II) (VMII) and 16 resin-composite crowns (Paradigm-MZ100 blocks) (PMZ) were milled using a CEREC-3D machine. Eight crowns of each group were cemented to their respective teeth using self-etching
resin cement (Panavia-F-2.0) (PAN), and eight were cemented using self-adhesive resin cement (RelyX-Unicem-Clicker) (RXU). Following storage for 1 week in water, specimens were subjected to uniaxial compressive cyclic loading in an Instron testing machine at 12 Hz for 1,000,000 cycles. Load was applied at the central fossa, and the cycle range was 60–600 N. Specimens were then subjected to microleakage testing. Data were statistically analyzed using factorial ANOVA and Post Hoc (Tukey HSD) tests. Results: All composite crowns survived compressive cyclic loading without fracture, while three ceramic crowns from the subgroup cemented with RXU developed surface cracks at the center of occlusal surfaces, extending laterally. Microleakage scores of ceramic crowns cemented with PAN were significantly
lower than those of the other three subgroups (p < 0.05). Conclusions: selleck After 1,000,000 cycles of compressive cyclic loading, PMZ composite molar crowns were more fatigue-resistant than VMII ceramic crowns. Cement type had a significant effect on fatigue resistance of the ceramic crowns but not the composite ones. Microleakage scores of ceramic crowns cemented with PAN were significantly lower than those of the other subgroups (p < 0.05). "
“Purpose: Conventional denture base polymethyl methacrylate (PMMA) is low in strength, soft, and brittle on impact. Improvements in the mechanical properties of denture base materials have been sought by adding different reinforcing phases to the PMMA matrix. The purpose of this work was to study the effects of mica reinforcement on the mechanical properties, flexural strength, and microhardness of PMMA denture base resin. Materials and Methods: Wet ground muscovite mica and Lucitone 199 original shade denture base resin were used.